1. based on the measurements that you made of the flash drive it’s time to design. Using your design worksheet, draw an image of your design. Be sure to include measurements of the design itself. You are limited to a final design that is no larger than 60mm x 100 mm.
2. Start designing. Begin by designing the space (hole) that will hold the flash drive itself. This is a good time to measure the flash drive AGAIN. Measure twice, cut once. A significant part of your grade is based on how well your measurements accurately allow for the flash drive to be hot glued into the 3d print.
3. After you have built the hole you may begin designing the outer case.